Plug & Play

 

 

eD-QDrive Easy Mount System

  • Transom Preparation

    Transom Preparation

    The vessel's transom is prepared according to the cutout template provided by eD-TEC. This cutout will enable the installation of the "Quick Mount Frame". No Further drillings will have to be made for the power unit. All cooling equipment and openings are located within the drive. This reduces the system's complexity and prevents unnecessary holes from being drilled into the hull.

  • Fit The Quick Mount Frame

    Fit The Quick Mount Frame

    After the transom has been prepared, the Quick Mount Frame can be fitted to the transom. This frame is bolted to the Hull using counter plates on the inside and sealed with silicone. Once this step is complete, the Hull is ready for marriage with the eD-QDrive.

  • Fixate the eD-QDrive

    Fixate the eD-QDrive

    The Transom is now fully prepared. The eD-QDrive can be aligned with the Quick Mount Frame and pushed into the hull. Fixating the drive and a seal on the frame will prevent water from leaking into the hull. With this step, the mounting of the drive is complete. What is left is easy and quick!

  • Plug&Play!

    Plug&Play!

    Now connected the eD-QDrive to the system cables. There is 1x High-Voltage Plug, 1x 24V In, 1x24V Out (Trim Tab/Foils), 2x CAN. Once the eD-QDrive is mounted and installed, the system can be booted up. The AI Box will automatically identify the drives and will integrate them accordingly.